Click here for complete Site Map
Thanks to Juan Trinidad who has kindly provided the information in Italics on this page.
Fixing light leaks in the Bellows
Most light leaks consist of pinholes in the very corners of the folds - due to wear.
Point a flash unit at bellows while looking from inside the camera. Popping the flash will identify pinhole points. Seal pinholes by applying Black Silicone Gasket Maker from auto supply stores.
Retest bellows with flash.
Alternatively I use a torch in the back of the camera in a darkened room. This shows the pin holes up quite clearly. For fixing - I use small pieces of black plastic electricians tape. This particularly suitable for post war Agfa folding cameras as it is similar to the material their bellows are made out of. However please note that black plastic electricians tape is only really a temporary repair as the tape needs cleaning off and replacing from time to time.
Also thanks to Frank Klee of Elgin, IL for the following info:
The following concoction has been found to be long lasting fix for fabric-plastic bellows in good looking condition but with corner pinholes.
- 1 teaspoon Elmer's glue
- 2 small drops liquid dish detergent
- 2 small drops black lampblack or shoe dye
mix well, apply to corners inside bellows with small art brush and with bellows open, immediately open--close-- open bellows a few times after application to work in the paste, open bellows and leave open at least 24 hours to dry.
Elmer's multipurpose glue is white and has been sold in USA for decades. It appears to be water based, dries flexible, smells neutral, and is used for porous or semiporous materials. Apply it to hard to reach areas inside the bellows using a hypodermic syringe and artist's brush but a small cake decorating tube or an air bulb such as that used to suck mucus out of an infant's nose could also be used. Three or 4 light applications are suggested. Open and close the bellows a few times after application and always let them dry overnight with bellows open. Check light tightness repeatedly using a flash inside the bellows while eyeballing the exterior in a darkened room. Back up this internal treatment with judicious application of black vinyl tape to exterior corners.
Thanks also to Charlie Stobbs for the following useful tip:
I have a repair for pinholes in bellows that has worked quite well. I put a small lamp inside the camera in a darkened room and push a pin down through each of the pinholes. Then (in the light) I put a small blob of black silicone rubber (RTV) on the point of the pin(s) and pull them back up through the holes. Then I put a small smear of RTV on the outside where the pins were (hopefully forming a rivet head of sorts to the blob on the inside). The camera should be left open for a day or two to allow the RTV to cure fully.
One question we often get asked is how to replace bellows. This is not something we have tried yet - however please check out our new page showing how to make an Isolette bellows!
Here also are a couple of links which might prove useful.
The website of "Camera Bellows" - one of the few manufacturers left
They are UK based and certainly make bellows suitable for Agfa Isolettes. Mario's website has more info:
Mario Groleau's excellent antique camera website
Mario has purchased at least one bellows from the above company talks about it and other aspects of camera restoration on his website. Well worth a look even if you are not intending to change a bellows.
Got a question or can't find the info you are looking for? Click HERE to contact us.
Click here for main Repair Page
Click here for complete Site Map
|